Dianna

Why won’t my dishwasher drain?

A dishwasher that doesn’t drain is a common issue faced in the kitchen. It is not necessary that the dishwasher is at fault rather the newly installed garbage disposal might be the reason as well. If you notice clogged water at the bottom of the dishwasher, the thing that should be done is to check for any blockage of the drain plugs present at the bottom of the dishwasher. Foodstuff, plastic paper, paper napkins may sometimes get clogged in the drain plugs thus preventing the dishwasher to drain properly.

This is the main reason why it is always recommended to scrape the leftovers and clean the dirty dishes before putting them in the dishwasher which can prevent clogging the garbage disposal. Clean the dishes with water before placing them in the dishwasher.

If you find the drain clean then consider checking the filters that are located either at the back or near the lower spray arm. Clean the debris clogged in the filter or around it. After checking the drain and the filter, check the draining tube through which the dirty water is dumped in the garbage disposal.

There are times when the food particles from the dishes get clogged in the tube that transfers dirty water from the dishwasher for disposal. Large food chunks get stuck in the pipe thus blocking the path.

The rubber tube present at the top drains dirty water from the dishwater to the disposal. It has a plastic plug that needs to be popped out, if the plug is not stuck out from the garbage port then the dishwasher will not be able to drain the dirty water and it will get clogged in the dishwasher itself.

Removing the plastic plug is very easy, start removing that and remember not to use the dishwasher when it is still connected to the electrical board. Release the clamp that holds the rubber tube and pulls the tube.

With the help of a screwdriver trying to find the plug, if the screwdriver gets all in the disposal then the problem is not with the disposal, but if you can feel the plastic plug stuck in between then you have got the solution to unclog the drainage of your dishwasher.

Try to punch the plastic out with the help of the screwdriver and if needed you can also take the help of a hammer through which a tapping force will be applied on the screwdriver that can push the plastic cup out. Keep in mind to remove the plastic completely from the circular hole.

Now unplug the disposal and drain all the leftover tiny pieces of plastic. After the disposal is cleaned properly you should replace the hose again, plug in the disposal and after following this process the dishwasher will now drain properly. The new garbage disposal is usually blamed for clogging the drain of the dishwasher.…

Why is My Home Air Conditioner Blowing Warm Air?

Air conditioner blowing hot or warm air? Need to make sense of what the issue is before calling an air conditioner expert? This blog is for you.

While there are many, numerous reasons your air conditioner is blowing hot air, we’ll go through the most well-known causes that you can fix or analyze without anyone else.

In the event that you need quick assistance, call us at (580) 215-0438 or get in touch with us on the web.
The thermostat is not set properly.

It might sound senseless; however we’ve witnessed it previously. Double-check your thermostat and ensure it isn’t set to “heat”. It might have been bumped by another person in the home.

Likewise, verify whether you have your thermostat set to “auto” or “on”. On the off chance that it’s set to “on”, that implies the fan will blow notwithstanding when the air conditioner is not really cooling. This makes your AC to blow hotter air out the vents when the outside unit is not operating.

There is a restriction in air flow.

A restriction in the air flow to and from your air conditioner frequently brings about insufficient air leaving the vents to cool your home. Confined air flow can likewise cause the compressor (the component that moves the refrigerant) in your air conditioners outside unit to freeze up.

This is ordinarily a consequence of at least one of the accompanying:

• The air filter hasn’t been changed in quite a while.
• You haven’t had maintenance done on your air conditioner this year (so the coils are dirty).

The outside unit isn’t getting power supply.

Your air conditioning is comprised of two primary parts – an outdoor unit and an indoor unit. The indoor unit houses the fan that blows air through your home, however, long story short; it can possibly blow cool air if the outdoor unit is working.

So if air is blowing out of your vents yet it’s not cold, it may be the case that the circuit breaker has tripped or the fuse has blown on the electrical circuit that gives power to your outside unit.

Check your circuit breaker or fuse panel to ensure the circuit is providing power supply to the outside air conditioning unit.

Point to Note: If the circuit breaker was tripped or fuse blown by the Air Conditioner, you have to call an expert promptly as there could be a huge issue.

Different Causes –

In all likelihood, in case you’re having issues with your air conditioner blowing hot or warm air, it’s either an issue with the compressor/outside unit or your air conditioner is low on refrigerant. You may likewise have a return duct that is broken or disconnected and is pulling in unconditioned air from outside or an attic space. Be that as it may, both of these issues need an expert’s assistance.

On the off chance that you need assistance with your air conditioner that is blowing hot air, and you’re in the Lawton, OK area, call us at (580) 215-0438 or get in touch with us on the web.…

Reasons Why a Vacuum Can Become Really Loud

Vacuuming may not be your loved household work, and it can turn out to be considerably progressively bothersome when it begins making an extremely loud noise. A loud vacuum noise can have one of a few potential issues. Most issues are effectively fixed. Sometimes, you may need to take your vacuum cleaner to the repair shop.
There is one drawback to vacuum cleaners however – the noise they make. Although running the vacuum around your home is fast and compelling, it is extremely loud.

You won’t most likely hear whatever else other than the noise it makes! Furthermore, nobody truly enjoys uproarious vacuum cleaner audio effects around their home. The inquiry lots of individuals wind up posing to themselves is – for what reason are vacuum cleaners so loud?

• Dirty Filters

In the event that your vacuum has all of a sudden turned out to be very loud, check the filter, as it might be dirty. At the point when the filters on a vacuum become too much dirty, the vacuum may begin running louder on the grounds that it is endeavoring to make suction. On the off chance that your filters are dirty, your vacuum is likely not suctioning suitably, either. To fix this issue, basically remove the filters in your vacuum, free them of the residue and rinse them out with warm water.

Change the filters once they are dry, and your vacuum should keep running at its ordinary sound level. Commonly, vacuum cleaners have 1 or 2 filters. One channel is close to the debris bag on standard vacuums. The other filter might be a HEPA filter.

• Clog

Clogs are regularly the guilty party when your vacuum cleaner is making a great deal of noise. While vacuuming, you may have sucked up an item – a button or a little toy, for instance. Also, the stop up might make the vacuum work more enthusiastically. Check for a clog in the tubes of your vacuum. In the event that you discover one, eliminate it by hand. On the off chance that it’s an extreme clog, have a go at eliminating it with a weaving needle or stick. On the off chance that the clog is terrible, take the vacuum cleaner to the repair shop.

• Broken Brush Bearing

A broken brush bearing might be the issue. At the point when a brush bearing breaks, the vacuum cleaner gets loud and begins to vibrate. To cure the issue, eliminate the brush and change it. In case you’re not open to making the fix yourself, take the vacuum cleaner to the repair shop.

• Broken Fan

The fan in the motor of your vacuum might be broken, making the vacuum run more loud than ordinary. At the point when dirt goes through the motor of the vacuum, it can gather on the fan, making it break. In the event that the fan in your vacuum motor is broken, it should be changed. Once more, you can do this fix yourself. Be that as it may, on the off chance that you don’t feel comfortable making the fix, take the vacuum cleaner to the repair shop.…